Crow Runner Link Instrukcja Użytkownika Pobierz pdf (Strona 15)

RUNNER LINK Gateway Configuring the Runner Link

Setting the Board to the Factory Default IP Address

1. Using Figure 3 on page 6 as a guide, short the Reset jumper pins using the

jumper installed on one of the pins.

2. Press the CONFIG button.

The board is now reset to the factory defaults.

NOTE

You can also reset the Runner Link by turning on power to the

board when the pins are shorted using the jumper. You can then

remove the jumper and plug it onto one of the pins for safe

keeping.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 28 29

Brak uwag

Crow Runner Link Instrukcja Użytkownika Strona 15